Replacing the fuel filter to the point: 1) Replace very 20K miles. 2) have the right filter for your case. 3) the engine off! Remove the top of the exhaust control system. 4) separating the water service (1 screw a piece of Seal) a. Cap Seal and old washing machine with T30 Torx bit. b. Siphon water at the bottom of the filter housing from the top of the box - Fuel AKA swamp. c. enough to avoid spilling fuel siphon when the container is opened. d. Install New Plug with washer. 3 Nm (27 in-lb). 5) FuelChanging the filter (filter 1, filter 2 seals, seals in the seat 2) A. Remove 5 screws and Torx T30 lifting upper filter housing with lines undisturbed. b. If a quantity of metal particles in the car to a professional! You have a big problem. c. Pull the old filter and seals in custody. d. Clean, if necessary, homes in Lower Austria, the remaining suction filter / fuel. NOTE: The removal of the houses in Lower Austria filter is not necessary. e. Install the new filter and seals. f. FILL canisterClean fuel to remove the air. (Approximately 650 ml or 22 ml) g. Install upper filter housing and secure with screws 5. Torque of 5 Nm (44 in-lb). 6) Installation of exhaust than the Control Panel. 7) If you VCD / VAG-COM work the fuel pump to remove air from the container. 8) If not, try and start the engine, run it at 2K RPM for 30 seconds. If the engine stops, start the engine. NOTE: turn key to accessories does not turn on the turn of the fuel pump from what I read, only when the key...
Tags: VW Jetta TDI, VW Jetta TDI Fuel Filter, Mann Fuel Filter, PU9362X, 1K0127400F, 1K0127400K, 1K0127434A, 1K0127434, 1K0127434B
No comments:
Post a Comment